Cause and Analysis of Laser Cutting Machine Accuracy and Dimension Error
Cutting accuracy is a measure of laser cutting machine is an important component of good or bad, but the laser cutting accuracy does not depend entirely on the device itself, but by a number of factors, there are several major factors:
1, the size of the laser beam through the focused spot
The smaller the spot size after laser beam gathering, the higher the cutting precision, especially the smaller kerf, the smallest spot size can reach 0.01mm.
2, the precision of the workbench's walking position determines the cutting accuracy
The higher the worktable accuracy, the higher the cutting accuracy.
3, the greater the thickness of the workpiece, the lower the accuracy, the greater the kerf.
As the laser beam is tapered, kerf is also tapered, the thickness of 0.3MM stainless steel than the 2MM kerf much smaller.
4, the workpiece material has a certain impact on the accuracy of laser cutting.
Under the same circumstances, stainless steel than aluminum cutting high precision, smooth section.
The error of the processing size is often encountered in the processing of laser cutting machine failure, this failure not only affects the production efficiency, but also increased production costs. Caused by processing errors in the size of the main reasons are as follows:
1. The signal line is not normal. In this case, you need to replace the signal cable.
2. The equipment and computer are not grounded properly. At this point you need a good grounding of the device and the computer.
3. The computer is not working properly. At this time need to repair the computer or replace the computer.
Computer operating system failure or infection with the virus. Need to reinstall the operating system or virus killing.
5. application software is not normal. Then need to re-install the software and motion control card driver software.
6. The power supply is unstable or by the interference signal. At this point need to install a voltage regulator or remove the interference signal.
7. Processing program is not prepared correctly. At this point need to check and repair processing procedures.
8. Processing parameters set incorrectly. To reset the correct processing parameters.




